September 15, 2026 — A severe fire incident involving a Bromic Heating Bromic Platinum 500 Series 39,800 BTU Gas Heater has raised significant safety concerns after a unit reportedly caught fire due to a defect in its internal rubber gas tube. The incident highlights a serious risk of fire and potential property damage, with a second heater from the same installation also found to be compromised.
Product Details
Incident Overview
On August 8, 2026, a consumer reported an alarming incident involving one of their two Bromic Heating Bromic Platinum 500 Series 39,800 BTU Mounted Outdoor Gas Heaters installed on a screened porch. Earlier that summer, one of the heaters spontaneously caught fire. Fortunately, the occupants were present in the room when the fire erupted and were able to act very quickly, extinguishing the flames with minimal damage before the fire department arrived. The Fire Department also responded to the residence.
A subsequent inspection revealed the alarming cause: a hole had burned through the internal rubber gas tube inside the heating unit. This defect created an open gas line that fed the fire, causing flames to shoot out from the back of the unit. The report emphasized the extreme danger, noting that if the fire had not been caught immediately, the entire house could have been engulfed in flames. Furthermore, the product uses an electrical switch to start, and the electric line was dangerously close to the open fire, posing an additional risk of an electrical fire.
Weeks after the initial fire, the original gas professional installer was called to inspect both the unit that caught fire and the other Bromic gas heater on the porch. The installer confirmed that the second heater was also damaged and was deemed to be at imminent risk of catching fire as well. This finding strongly suggests a manufacturing defect that could lead to widespread hazards if not addressed.
Safety Concerns
The incident involving the Bromic Platinum 500 Series Gas Heater underscores several critical safety concerns for consumers:
- Immediate Fire Hazard: The most pressing danger is the potential for uncontrolled fires. A defect such as a hole in the internal rubber gas tube creates a direct pathway for gas to escape and ignite, fueling intense flames that can shoot out from the unit, as described in the incident report.
- Rapid Fire Escalation and Structural Damage: Had the occupants not been present to quickly extinguish the fire, the open gas line, combined with the proximity to electrical components, could have rapidly escalated into a major structural fire, potentially leading to the complete destruction of the home and its contents.
- Systemic Manufacturing Defect: The discovery that a second, seemingly undamaged heater also harbored a similar defect and was at risk of catching fire suggests a potential systemic manufacturing flaw rather than an isolated incident. This indicates that other units of the same model may contain the same hidden, dangerous defect, posing an unseen threat to consumers.
- Risk to Life and Property: Fires of this nature pose significant risks of serious injury or fatality to homeowners, residents, and any guests or pets. Additionally, the potential for extensive property damage, ranging from localized destruction to the complete loss of a home, is extremely high.
What Consumers Should Do
If you own a Bromic Heating Bromic Platinum 500 Series 39,800 BTU Gas Heater or a similar Bromic gas heater model, it is crucial to take immediate preventative measures:
1. Discontinue Use Immediately: If you own this specific model or any similar Bromic gas heater, discontinue use of the unit(s) immediately. Turn off the gas supply to the unit(s) at the main valve and ensure it remains off.
2. Professional Inspection: Do not attempt to inspect, operate, or repair the unit yourself. Contact a qualified and licensed gas professional to thoroughly inspect your Bromic Platinum 500 Series heater(s) for any signs of damage or potential defects, paying particular attention to the internal gas lines and electrical components.
3. Check for Affected Product: Verify if your heater is the Bromic Platinum 500 Series 39,800 BTU Gas Heater. You can typically find the model number and BTU rating on a label affixed to the product or in its owner’s manual.
4. Report Incidents: If you have experienced a similar incident, suspect a defect in your unit, or have any safety concerns, report it immediately to the U.S. Consumer Product Safety Commission (CPSC) at www.cpsc.gov.
5. Maintain Awareness: Stay informed about any potential recalls, safety alerts, or further guidance from the manufacturer or regulatory bodies regarding this product.
Manufacturer’s Response
The manufacturer, Bromic Pty Ltd, has acknowledged receipt of the incident report.
Legal Help Available
If you or a loved one has been injured by a defective product or suffered property damage due to a product malfunction, you may be entitled to compensation. The experienced product liability attorneys at Farzan Law understand the complexities of defective product cases and can help you navigate the legal process. Farzan Law is a California based Personal Injury law firm focusing on protecting the rights of those wrongfully injured.
Licensed to practice law ONLY in California.
Contact us today for a free consultation: 424-325-3112
Our legal team has successfully represented clients in product liability cases involving defective appliances, automotive defects, medical devices, and consumer products. We work on a contingency fee basis, which means you don’t pay unless we win your case.
Note: This information is based on incident reports provided by the U.S. Consumer Product Safety Commission. If you find information that is incorrect, please contact us immediately so we can correct the post to reflect accurate information.
Disclaimer: The information provided in this post is not intended to be legal or medical advice. This article is based on publicly available incident reports. The incidents mentioned have not necessarily been independently verified or adjudicated.